EasyManua.ls Logo

MG Hector Plus - Wheels and Tyres; Maintenance

MG Hector Plus
250 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
185184
Wheels and Tyres
Original tyres guarantee optimum matching of
riding comfort, tread life and performance.
Be sure to use wheels and tyres of
specified specifications. The use of
w h e e l s a n d / o r t y r e s o f o t h e r
specifications may result in abnormal
operation of ABS and other relevant
components and even cause collision
accidents.
Please consult the MG Authorised
Service Center before replacing original
tyres or wheels.
Otherwise, it may cause personal injury
and damage the vehicle or other
properties.
Caution
The tyre pressure shall meet provisions of the
Manual so as to ensure optimum matching of
driving comfort, safety and driveability.
Refer to the tyre load information label for the
correct tyre pressure. The label is on the sill
plate below the driver's door.
At the time of cold start, check the tyre pressure
with an accurate tyre pressure gauge. After check
of tyre pressure, tighten the valve core cap.
Make sure to check the tyre pressure at
the time of cold start. The reading
measured after the tyre temperature has
increased shall not prevail. tyres will
become hot after traveling for 1.6 Km
and will not cool down completely within
3h after stopping.
Note
Check the tyre pressure each time when
refueling or at least every month. Incorrect
tyre pressure may:
Ÿ Increase tyre wear
Ÿ Affect the vehicle manoeuvrability and
safety
Ÿ Affect the riding comfort
Ÿ Reduce the fuel economy
Ÿ Vehicle overload is prohibited.
Ÿ Be sure to keep a proper tyre inflation
pressure.
Ÿ Be sure to check the tyre inflation
pressure at the time of cold start
(ambient temperature).
Note
Excessively low tyre pressure will cause
overheat of the tyre, leading to internal
damage and layered tread and even tyre burst
when driving at a high speed. Even if the tyre
pressure was restored later, driving under too
low pressure may have damaged the tyre.
Tyre and Wheel Maintenance
Running over sharp objects may damage tyres
and wheels. If you have to run over these
objects, please slow down.
Maintenance
VEHICLE SERVICE & MAINTENANCE
Do not touch the curb when parking.
Regular Tyre Check
Ÿ Appearance damage.
Ÿ Foreign material.
Ÿ Piercing.
Ÿ Cut.
Ÿ Crack.
Ÿ Protruding on side wall.
It shall also inspect the wheel for damage.
Tyre defects including the above defects may
lead to vehicle out of control, causing personal
injury.
In case of damage or abnormal wear of tyre or
wheel, please consult the MG Authorised
Service Center for help.
The vehicle is equipped with radial tyres. MG
Motor suggests replacing with radial tyres of
the same size, pattern, tread wear,
temperature and rated speed.
The use of tyres with different size than
the original tyres may cause the tyre and
the vehicle component to interfere with
each other, thus causing damage to the
tyre and vehicle.
Note
The tyre must be replaced when the tread
wear indicator appears. When the tread
depth is equal to or less than 1.6 mm due to
wear, the tread wear indicator will appear
between the tread grooves.
Do not drive the vehicle in case of tyre
wear or damage. The worn or damaged
tyres may lead to the vehicle out of
control and cause collision accidents,
resulting in personal injury and damage
of vehicle or other properties.
Caution
If the vehicle is equipped with tyre
pressure monitoring system, the tyre
repairing liquid for tyre repair may result
in the failure of the tyre pressure
moni tor i ng s yst e m se nso r . I t is
suggested to go the MG Authorised
Service Center for inquiries and repair.
Caution
Internal Tread Wear Indicator
Check the tyre tread depth as per the tread
wear indicator regularly. The mark on the tyre
wall indicates the position of the tread wear
indicator.
VEHICLE SERVICE & MAINTENANCE

Table of Contents

Other manuals for MG Hector Plus

Related product manuals