MG Hector Plus - Wearing

4140
SEATS AND PROTECTIVE DEVICES SEATS AND PROTECTIVE DEVICES
Seat Belt
The seat belt is designed only for one
passenger each time. It is not applicable to a
passenger under 12 years old or under 150 cm
high. Check all parts of the seat belt system for
damage and abnormal function regularly.
Please replace the damaged parts and
components. It is strongly recommended to
have the seat belt or deployed seat belt
tensioner at the MG Authorised Service
Center replaced after an accident.
Seat Belt Force Limiter*
It is configured on the seat belts for the
driver’s seat and the left seat of second row.
For some models, the front passenger’s seat
belt is also configured with a force limiter.
The force limiter can reduce the stress applied
on the body through the seat belt damping
release in case of a collision accident.
Seat Belt Pretensioner*
Depending on different models, it is
configured on the seat belt for the driver’s
seat, front passenger’s seat of the left seat of
the second row. In case of a severe head-on or
rear-end collision, the front part of the seat
belt will be tensioned.
The deployed seat belt pretensioner must be
replaced by the MG Authorised Service
Center. The seat belt pretensioner can only be
deployed once.
Make sure that the seat belt is not
damaged or clamped by a sharp object.
Prevent dust from getting in the seat belt
recoiler.
Note
Improper operation (for example
removal or installation of seat belt or
seat belt anchor buckle) will trigger the
seat belt tensioner, leading to injury
risks.
Warning
Buckle the seat belt each time before
driving the vehicle. In case of an accident,
a passenger who does not buckle the seat
belt may be at risk.
Warning
It is not allowed to add any accessory or
other object that may interference with
the operation of the seat belt. Do not
change any seat belt component.
Note
The seat belt shall not be buckled against
a hard or fragile object in your pocket.
Otherwise, the hard object will hurt you
and the fragile object may be damaged in
case of emergencies.
Warning
Pay attention to prevent foreign matters
from getting in the seat belt buckle (such
as sunflower seed shell and button);
otherwise the seat belt buckle will fail.
Note
Seat Backrest Folding 5 Seater layout diagram
As shown in the figure, pull the strap on the
back of the seat and fold the backrest forward.
To recover, pull the drawstring and unfold the
backrest until it is locked in position.
Seat Layout Diagram
6 Seater layout diagram
Wearing
1. Pull out the seat belt from the recoiler, and
fasten it across the body without twisting.
2. Put the latch plate in the buckle for fixing.
Pull the shoulder belt forcibly to adjust the
tightness degree of hip belt.
7 Seater layout diagram