3736
Pull up the handle near the seat cushion; adjust
the backrest inclination angle to a proper
position; then, release the handle. Please do
not lean on the seat backrest while adjusting.
After adjusting the seat backrest, try to shake
the backrest to ensure that the backrest is
locked.
As shown in the figure, turn the adjustment
switch forward and backward, and the
backrest will be folded forward or unfolded
backward. Release the switch when it is
adjusted to a proper position.
Electric Adjustment Type*
If the backrest does not move when the
switch is turned, the backrest may be
already at its limit position, or the vehicle
battery is out of power. Please check for
confirmation. Never turn the switch
forcibly to avoid damaging it.
Note
Seat Backrest Adjustment
Manual Adjustment Type*
The backres t p lays an i mporta nt
protection role when the vehicle is
running. Unlocked backrest may cause
severe personal injuries in case of sudden
braking or a collision.
Any time after adjusting the seat
backrest, shake the backrest to check
whether it is locked even though no
passenger occupies the seat.
Warning
SEATS AND PROTECTIVE DEVICES SEATS AND PROTECTIVE DEVICES
Turn the handle on the outer side of the seat
upward and downward until the seat is
adjusted to the desired height. While adjusting
the seat height, the seat must be loaded.
Therefore, please sit on the seat before
adjustment; otherwise the adjustment device
may be damaged.
As shown in the figure, rotate the height
adjustment switch on the outer side of the seat
cushion, and then release the switch after the
seat is adjusted to proper height.
The electrically-adjustable front passenger’s
seat cannot be adjusted upward or downward.
Manual Adjustment Type*
Driver’s Seat Height Adjustment
Electric Adjustment Type*
The seat backrest inclination angle is
adjustable within a certain range.
First hold the backrest with hands because the
backrest will be folded quickly and may cause
impact or injuries after the backrest release
belt is pulled up. Then, pull the backrest
release drawstring on the seat side backward,
and release the drawstring after a proper angle
is obtained.
To fold the seat backrest, pull up the
drawstring and fold the backrest forward.
Overturning the seat cushion first and then
folding the backrest can fold flat the backrest
to the greatest extent.
Seat Backrest
Adjustment and Folding
Ventilation Seat Control Button
Some variants of vehicles have the ventilation
function for the front seats. As shown in the
image, the control button for ventilation is
located in the side of console. Press the button
to active the ventilation function, meanwhile 3
LED lights are on and with the maximum fan
speed; press the button again, it remains 2 LED
lights on and with medium fan speed; press the
button again, only 1 LED light on and with
minimum fan speed; press button again, the
ventilation function will be turned off.
Customer could adjust the fan speed to get the
appropriate ventilation performance and keep
a comfortable driving experience.
To Next Page
Loading...
