9392
Electronic Parking Brake (EPB)
Working Indicator*
The electronic parking brake (EPB) working
indicator illuminates as the electronic parking
brake is pulled up. This indicates that the
vehicle is in a parking state.
This indicator goes out as the electronic
parking brake is released. This indicates that
the vehicle is out of the parking state.
This indicator keeps illuminated as long as the
electronic parking brake engages firmly.
For details about the electronic parking brake
(EPB), please refer to “Parking Brake” under
“Driving and Controls”.
Electronic Parking Brake (EPB)
Fault Warning Lamp*
The electronic parking brake fault warning
lamp illuminates after the ignition switch is
turned on and it goes out several seconds
later. This indicates that both the warning
lamp and the electronic parking brake function
module can work normally.
In case of an electronic parking brake fault or a
warning lamp fault, it will be indicated in any of
the following ways:
Ÿ The lamp does not illuminate when the
ignition switch is turned on.
Ÿ The lamp does not go out after it
illuminates.
Ÿ The lamp Illuminates during driving.
Once the electronic parking brake (EPB) fault
warning lamp shows the above abnormalities,
please contact the Service Center in time. An
electronic parking brake fault can cause the
vehicle to coast.
INSTRUMENTS AND CONTROLSINSTRUMENTS AND CONTROLS
Automatic Vehicle Hold (AVH)
Working Indicator*
The automatic vehicle hold (AVH) working
indicator illuminates after the ignition switch is
turned on and it goes out several seconds
later. This indicates that the indicator can
work normally. For certain vehicle models, the
indicator does not illuminate when the ignition
switch is turned on.
This indicator illuminates when the automatic
vehicle hold function works and the vehicle is
being parked.
It goes out as the vehicle gets out of the
parking state.
For details about automatic vehicle hold
(AVH), please refer to “Parking Brake” under
“Driving and Controls”.
Automatic Vehicle Hold (AVH)
Fault Warning Lamp*
The automatic vehicle hold (AVH) fault
warning lamp illuminates after the ignition
switch is turned on and it goes out several
seconds later. This indicates that both the
warning lamp and the automatic vehicle hold
function module can work normally. For
certain vehicle models, the warning lamp does
not illuminate when the ignition switch is
turned on.
In case of an automatic vehicle hold function
module fault or a warning lamp fault, it will be
indicated in any of the following ways:
Ÿ The lamp does not illuminate when the
ignition switch is turned on.
Ÿ The lamp does not go out after it
illuminates.
Ÿ The lamp Illuminates during driving.
Once the automatic vehicle hold (AVH) fault
warning lamp shows the above abnormalities,
please contact the MG Authorised Service
Center in time.
Parking Brake Telltale may blink in
cluster after ignition off few times. This is
normal phenomenon*.
Note*
To Next Page
Loading...
