MG Hector Plus - ABS Fault Warning Lamp

8786
Position Lamp Indicator
This indicator illuminates when the position
lamp is turned on.
Headlamp High Beam Indicator
The high beam indicator illuminates when the
headlamp high beam is turned on.
Engine Malfunction Indicator Lamp (MIL)
This indicator lamp illuminates when the
ignition switch is turned on but the engine has
not started. This indicates that the indicator
lamp bulb can work normally. The lamp goes
out after the engine is started. This
malfunction indicator lamp (MIL) illuminates
upon occurrence of any component or
subsystem fault related to the emission
system. Once the electronic control module
(ECM) detects any fault, the malfunction
indicator lamp will keep illuminated. In case
that serious misfire is detected, the
malfunction indicator lamp will flash
constantly. Serious misfire can cause damage
to the catalytic converter. In case of this, the
electronic system of the vehicle will switch to
INSTRUMENTS AND CONTROLSINSTRUMENTS AND CONTROLS
The ABS warning lamp will illuminate
immediately the ignition switch is turned on. It
indicates that the system is conducting self-
inspection and the warning lamp bulb can
work normally. The warning lamp goes out
several seconds later.
When the ABS warning lamp gets into the
following states, please consult the nearest
MG Authorised Service Center.
Ÿ Not illuminated as the ignition switch is
turned on
Ÿ Always illuminated
Ÿ Illuminated during driving
ABS Fault Warning Lamp
an emergency running procedure so that you
can continue the trip. However, we advise you
to go to the nearest MG Authorised Service
Center for fault removal as soon as possible. If
MIL illuminates for a while and then goes out, it
is normal, not indicating any system fault.
If MIL illuminates, it indicates a fault that
must be noted. Continuous driving after
MIL has illuminated can cause damage to
the emission control system, and reduce
fuel economy and vehicle controllability.
We advise you to go to the nearest MG
Authorised Service Center for vehicle
repair as soon as possible.
Caution
If the ABS warning lamp illuminates during
driving, it indicates possibility of an ABS fault.
Though the vehicle can run normally without
ABS function, but we strongly advise you to go
to the nearest MG Authorised Service Center
for ABS inspection and necessary repair.
Illuminated ABS warning lamp can also
indicate that the brake cannot work
normally. If you fail to keep the brake in
an agreeable working condition, collision
may happen and as a result, personal
injuries, and damage to the vehicle or
other properties can occur.
Caution