9190
If the brake system warning lamp does
not illuminate after the parking brake
engages with the ignition switch turned
on, please do not drive the vehicle.
Please ensure that light-emitting diode of
the warning lamp works normally. If the
lamp does not illuminate when the
parking brake engages with the ignition
switch turned on, even though light-
emitting diode of the warning lamp
works normally, we still advise you to go
to the nearest MG Authorised Service
Center to inspect the brake system.
These phenomena indicate possibility of
a brake system fault.
If you fail to keep the brake in an
agreeable working condition, collision
may happen and as a result, personal
injuries, and damage to the vehicle or
other properties can occur.
Caution
Model with Electronic Parking Brake
The brake system warning lamp illuminates
after the ignition switch is turned on and it
goes out several seconds later. This indicates
that the warning lamp can work normally.
If the brake system warning lamp keeps
illuminated or illuminates during driving, it
indicates possibility that the brake fluid level in
the fluid reservoir is too low or an EBD system
fault has occurred. In case of this, the
operation steps are the same as those for
model with mechanical hand brake.
Engine Immobilizer System Indicator
This indicator illuminates when the door is
opened. It goes out after the engine is started.
This indicates that the indicator can work
normally. Refer to information on engine
immobilizer system given in “Driving and
Controls”.
INSTRUMENTS AND CONTROLSINSTRUMENTS AND CONTROLS
Driver Fasten-Seat-Belt Warning Lamp
The seat belt warning lamp illuminates if the
driver does not fasten the seat belt properly
after the ignition switch is turned on.
Following this, the following circumstances
will appear unless the driver fastens the seat
belt properly:
Ÿ The seat belt warning lamp keeps
illuminated
Ÿ If the vehicle speed exceeds 20 km/h, the
warning lamp will flash and the warning
buzzer will buzz for a certain time.
Front Passenger Fasten-Seat-Belt
Warning Lamp*
The seat belt warning lamp illuminates if the
front passenger seat is occupied but the
occupant does not fasten the seat belt
properly after the ignition switch is turned on.
Following this, the following circumstances
will appear unless the front passenger fastens
the seat belt properly:
Ÿ The seat belt warning lamp keeps
illuminated
Ÿ If the vehicle speed exceeds 20 km/h, the
warning lamp will flash and the warning
buzzer will buzz for a certain time.
This warning lamp does not illuminate if the
front passenger seat is not occupied after the
ignition switch is turned on.
Fuel Level Too Low Warning Lamp
This warning lamp will illuminate immediately
the ignition switch is turned on. It indicates
that the system is conducting self-inspection
and the warning lamp bulb can work normally.
If this lamp keeps illuminated after the ignition
switch is turned on or it illuminates during
driving, it indicates that the fuel amount in the
fuel tank is insufficient and you should
replenish the fuel in time.
Do not exhaust the fuel, otherwise the
catalytic converter can be damaged.
Note
To Next Page
Loading...
