8382
INSTRUMENTS AND CONTROLSINSTRUMENTS AND CONTROLS
1. Speedometer
2. Engine anti-theft system indicator /
Immobilizer
3. Transmission Failure Warning Light*
4. Position Light Indicator
5. Engine Failure Warning Light
6. Left Turn Signal / Hazard Warning
Indicator
7. Front Fog Light Indicator*
8. Headlights High Beam Indicator
9. Rear Fog Light Indicator
10. Fuel Water Indicator Light*
11. Glow Plug Indicator Light*
12. Driving Computer Information Tab
13. Particle Trap Indicator Light*
14. Fault Information Prompt
15. Emergency Stop Light*
16. Right Turn Signal / Hazard Warning
Indicator
17. Engine Tachometer
18. Electronic Hand Brake Failure Warning
Light*
19. Electronic Hand Brake Work Indicator*
20. Automatic Parking (AVH) Work
Indicator*
21. Automatic Parking (AVH) Fault
Warning Light*
22. Brake System / Hand Brake Indicator /
EBD Warning Light
23. Oil Gauge
24. Water Temperature Gauge
25. Start and Stop System Work Indicator*
26. Start And Stop System Shutdown
Indicator*
27. Electric Power Steering (EPS) Warning
Light
28. Driver side Seat Belt Warning Light
29. Charging System Failure Warning Light
30. 48v System Failure Warning Light*
31. Low Oil Pressure Warning Light
32. Passenger side Seat Belts Warning Lights
33. Constant Speed Cruise Work Status
Indicator*
34. Fuel Level Low Warning Light
35. Distance to empty (Fuel range)
35a. SCR (Selective Catalytic Reduction)
Warning Light
36. Gear Display*
37. Total Odometer
38. Display
39. Water Temperature Warning Lamp
40. Tyre Pressure Monitoring System
(TPMS) Fault Indication light*
41. ABS Warning Light
42. Airbag Failure Warning Light
43. Electronic Stability Control System
(ESC) shutdown refers to Light*
44. Electronic Stability Control (ESC) Fault
Alarm Notice light*
When the ignition switch is turned on, it is
used as a function test.
Try, most control lights will be activated for a
short time bright.
Control indicator color one position:
Red = dangerous, important reminder.
Yellow = warning, message, fault.
Green = Confirm Enable.
Blue = Confirm Enable.
As you turn on the ignition switch, the engine
oil pressure too low warning lamp illuminates
and it goes out after the engine gets started.
This indicates that the indicator bulb can work
normally.
If this warning lamp illuminates while the
engine is running, it indicates that the engine
oil pressure may have dropped to a dangerous
level. Please stop the engine and check the oil
level immediately.
If the oil level is too low, please add the
specified engine oil to the appropriate level.
Please refer to the information about engine
oil level check provided in “Vehicle
Maintenance”. If the oil level is normal, please
Turn Signal Lamp /
Hazard Warning Indicator
The turn signal lamp / hazard warning lamp
indicator is used to confirm whether the
outside turn signal lamp / hazard flasher can
work normally. If you find that the green
arrow does not flash as you send a turning
signal or press the hazard warning button,
please inspect the fuse and bulb and if
necessary, replace them.
These indicators are essential for
assurance of driving safety. If the turn
signal lamp or the hazard flasher
indicator bulb has burnt out, please
replace it immediately. If you fail to keep
these indicators in an agreeable working
condition, accident may happen and as a
result, personal injuries, and damage to
the vehicle or other properties can occur.
Caution
If the flashing time is shorter than
normal, it indicates that the turn signal
lamp bulb has burnt out and must be
replaced.
Note
Engine Oil Pressure Too Low
Warning Lamp
To Next Page
Loading...
