209
Periodic Maintenance - Service Schedule-Z Car Full Electric
` 1 Month 6 Months 1 Year 2 Years 3 Years 4 Years 5 Years 6 Years 7 Years 8 Years 9 Years 10 Years
OPERATION / PROCESSES FOR PERIODIC SERVICE
SCHEDULE
Replacement
Frequency: Km /
Year whichever is
earlier
1000
5000
10000
20000
30000
40000
50000
60000
70000
80000
90000
100000
Check the level and concentration of coolant, and add to the
standard level as necessary.
80K KM/ 4 Years* I I I I I R* I I I R I I
Check the status of A/C system pipeline such as the compressor,
the cooling pipeline and the condenser, and clean relevant surfaces
as necessary.
Inspection only I I I I I I I I I I I I
Check the status of brake vacuum booster and hose. Inspection only I I I I I I I I I I I I
Check the drive motor mounting bracket. Inspection only I I I I I I I I I I I I
Vehicle Bottom
Check the appearance of high-voltage connector and if it is fitted
properly; check the surface of high-voltage connector for damage
and if it is fitted in place.
Inspection only I I I I I I I I I I I I
Check the high-voltage harness for mutual interference, wear or
damage.
Inspection only I I I I I I I I I I I I
Check the appearance of vent valve for damage, and check the
marking for fitting to see if it is moved.
Inspection only I I I I I I I I I I I I
Check the status of manual service switch to ensure reliable
mounting and clean up the dust on the surface.
Inspection only I I I I I I I I I I I I
Check the mounting position of the cooling water pipe clip to
ensure reliable sealing.
Inspection only I I I I I I I I I I I I
Check the marking for fitting the mounting bolt to see if it is moved
and ensure the bolts are fastened.
Inspection only I I I I I I I I I I I I
Check the appearance of housing (including the bracket) for crack
or deformation.
Inspection only I I I I I I I I I I I I
Check the appearance of high-voltage battery pack grounding wire
and replace it as necessary.
Inspection only I I I I I I I I I I I I
Symbol Abbreviation : R - Replace • I - Inspect- Top up if require-Adjust-Clean-Refill. Check the coolant level and top up as required, replace if it is contaminated/discoloured or there is sludge formation.
** Tightening of underbody fasteners, door adjustments and functional checks of all the systems during every service is mandatory - Check and Rectify.
Maintenance Interval
To Next Page
Loading...
