MG ZS EV - Page 222

210
Periodic Maintenance - Service Schedule-Z Car Full Electric
` 1 Month 6 Months 1 Year 2 Years 3 Years 4 Years 5 Years 6 Years 7 Years 8 Years 9 Years 10 Years
OPERATION / PROCESSES FOR PERIODIC SERVICE
SCHEDULE
Replacement
Frequency: Km /
Year whichever is
earlier
1000 5000
10000 20000 30000 40000 50000 60000 70000 80000 90000
100000
Vehicle Interior and Exterior
Check the equilibrium state of the high-voltage battery pack and
carry out equalizing charge as necessary.
Inspection only I I I I I I I I I I I I
Check the status and thickness of front and rear brake pads and
brake discs, and replace them as necessary.
Inspection only I I I I I I I I I I I I
Check brake pipes and hoses for condition and security. Ensure that
hoses are not twisted or kinked.
Inspection only I I I I I I I I I I I I
Check the wheel bearings and drive shaft sleeve. Inspection only I I I I I I I I I I I I
Check the suspension and steering system for leakage or wear. Inspection only I I I I I I I I I I I I
Check the tread depth to see if the tyre is worn or damaged
abnormally. Check the four-wheel alignment data and perform front
and rear wheel rotation as appropriate.
Inspection only I I I I I I I I I I I I
Check the tyre pressure and make adjustment as necessary. Inspection only I I I I I I I I I I I I
Check if the chassis and underbody bolts and nuts are fastened or
fixed, and replace them as necessary.
Inspection only I I I I I I I I I I I I
After Maintenance and Repair
Use diagnostic software to reset maintenance interval indicator.
Check for fault codes and determine operation status of the control
systems.
Inspection only I I I I I I I I I I I I
Check the status and function of communication module with the
scan tool.
Inspection only I I I I I I I I I I I I
Check software version of electronic control units and upgrade to
latest version if available.
Inspection only I I I I I I I I I I I I
Carry out the road test, and check the status and function of power
system, brake, steering and other systems.
Inspection only I I I I I I I I I I I I
Symbol Abbreviation : R - Replace • I - Inspect- Top up if require-Adjust-Clean-Refill. Check the coolant level and top up as required, replace if it is contaminated/discoloured or there is sludge formation.
** Tightening of underbody fasteners, door adjustments and functional checks of all the systems during every service is mandatory - Check and Rectify.
Maintenance Interval