MG ZS EV - Page 27

15
Warning
Message
Procedure
Brake Fault
Indicates that a fault has been
detected within the braking
system. Stop the vehicle
as soon as safety permits,
switch the vehicle power
system OFF, and contact an
MG Authorised Repairer
immediately.
Stability
Control
Fault
Indicates that the SCS system
has detected a fault. Please
contact an MG Authorised
Repairer immediately.
Traction
Control
Fault
Indicates that the TCS system
has detected a fault. Please
contact an MG Authorised
Repairer immediately.
Parking
System
Fault
Indicates that the EPB system
has detected a fault. Please
contact an MG Authorised
Repairer as soon as possible.
Park Brake
Force Not
Enough
Indicates that the electronic
parking brake system has
detected a fault when parking.
Please contact an MG
Authorised Repairer as soon
as possible.
Warning
Message
Procedure
Autohold
Fault
Indicates that the auto hold
function has detected a fault.
Please contact an MG
Authorised Repairer as soon
as possible.
Hill Descent
Control Fault
Indicates that the HDC
system has detected a
fault. Please contact an MG
Authorised Repairer as soon
as possible.
EPS
Performance
Reduced
Indicates that the electric
power steering system (EPS)
has a general failure and the
performance is reduced. As
soon as conditions permit,
safely stop the vehicle and
switch the vehicle power
system to the OFF position.
After a short while, switch
the vehicle power system to
the READY position, drive
the vehicle a short distance
and monitor the operation of
the steering. If the message is
still displayed or the steering
assistance reduced, please
contact an MG Authorised
Repairer immediately.
Warning
Message
Procedure
EPS
Assistance
Failure
Indicates that the electric
power steering system (EPS)
has detected a fault. Please
contact an MG Authorised
Repairer immediately.
Steering
Angle Fault
Indicates that the steering
angle sensor has failed. Please
contact an MG Authorised
Repairer as soon as possible.
Steering
Angle
Uncalibrated
Indicates that the steering
angle sensor is not calibrated.
Please contact an MG
Authorised Repairer as soon
as possible.
ESCL Fault
Indicates that the ESCL has
detected a fault. As soon
as conditions permit, safely
stop the vehicle and switch
the vehicle power system to
the OFF position and contact
an MG Authorised Repairer
immediately.
Instruments and Controls
1