MGC INX-10A Series - 6.5 Independent Mode Configuration Options; 6.5.1 NACs 1 and 2 Configured as Signals

73
Configuration
6.5 Independent Mode Configuration Options
NAC circuits on the INX-10A can be configured to drive both Signals and Strobes.
6.5.1 NACs 1 and 2 Configured as Signals
To configure NAC1 and NAC2 to drive signals set SW3-7 to 0 (OFF).
Configure the Strobe Manufacturer and Signal Rate by setting SW4-4, SW4-5, SW4-6, SW5-1
SW5-2 and SW5-3 as described in Table 18.
Notes: Using Independent Mode in a Two Stage Application
When driving Signals and Strobes in a Two Stage Application configure the Alert Rate
by setting SW4-1, SW4-2 and SW4-3 as follows:
100 - Uses Strobe Manufacturer Sync Rate
010 - Continuous
110 - 0.5s ON, 2.5s OFF, Repeat (20 PPM as in FA-1000 or FX-2000)
001 - 20 PPM, 50% Duty Cycle
Table 18 Independent Mode DIP Switch Settings - NAC1 and NAC2 configured as
Signals
NAC3 NAC4 and NAC5 NAC1 and NAC2 CONFIGURE SWITCHES AS SHOWN
Strobe Manufacturer
(SW5 1-3)
Signal Rate
(SW4 4-6)
SW3 SW4 SW5
Mircom/Amseco Continuous
Mircom/Amseco Temporal
Mircom/Amseco March Time
Mircom/Amseco California
Mircom/Amseco 120 PPM, 50% Duty Cycle
System Sensor Continuous
i
ON
1
8
234567
ON
1
8
234567
ON
1
8
234567
ON
1
8
234567
ON
1
8
234567
ON
1
8
234567
ON
1
8
234567
ON
1
8
234567
ON
1
8
234567
ON
1
8
234567
ON
1
8
234567
ON
1
8
234567
ON
1
8
234567
ON
1
8
234567
ON
1
8
234567
ON
1
8
234567
ON
1
8
234567
ON
1
8
234567
ON
1
8
234567
ON
1
8
234567
ON
1
8
234567
ON
1
8
234567