7.4 Left and Right Arrow
When the Zip Navigator is stopped, press the appropriate turn
command and keep depressed until the degree of turn is achieved,
then press the forward button for the Zip Navigator
to go forward.
Whilst the Zip Navigator is moving, press the appropriate turn
command, and keep depressed until the degree of turn is achieved.
Momentary pressure will make a small adjustment to the direction,
whilst prolonged pressure will increase the degree of turn and speed
of the turn.
7.5 Speed Control – Manually and Remotely
Under manual control, you can adjust the speed by turning
the speed control button clockwise [increase speed] or
anti-clockwise [decrease speed]. When changing to the remote
control, irrespective of the speed level indicated on the display, the Zip
Navigator will always start at speed 2.
7.6 Keypad Unlock and Lock
The remote control has two buttons at the top which allow you to
LOCK and UNLOCK the keypad. This will eliminate accidental button
input when the remote is kept in your pocket. The STOP button will
continue to work, when the LOCK feature is activated.
7.7 Remote Range and Safety Stop
The Zip Navigator can be remotely controlled up to 100m. If the
remote control loses contact with the Zip Navigator, then the
automatic safety stop will initiate after ve seconds. This is for the
protection of your Zip Navigator, yourself and others. If the Zip
Navigator was last activated using the manual control, the auto safety
stop feature will not operate. Please note, the top left UNLOCK button
will ash every 3 seconds while the Zip Navigator is running under
remote control.
7.8 Pairing a Remote
In the unlikely event that your remote loses pairing with your Zip
Navigator, or you have replaced your remote, it will need to be paired
as follows:
1. Lift the main battery handle, disengaging the battery terminals.
2. Hold down the STOP Button on the remote until both the LOCK and
UNLOCK buttons illuminate and remain solid– then release the STOP
Button.
3. Re-engage the main battery by pushing the handle back down,
ensuring the lights on the remote remain illuminated.
4. The remote will synchronise with the Top Box – the process will
be complete once the LOCK and UNLOCK buttons are no longer
illuminated
Please note, if you do not connect the Zip Navigator, as per point 3,
with a battery, the remote will exit pairing after one minute.
MGI Zip Navigator User Manual 16
To Next Page
Loading...
