9.3 Parts Installed During Warranty
Warranty coverage for components installed during a motorised
Zip Navigator’s warranty period shall consist of the duration of the
Zip Navigator’s warranty period, provided the warranty installation is
performed by MGI, an authorised service centre or the Zip Navigator
owner on approval. Replacement of parts under warranty will not
extend the warranty of the Zip Navigator or parts.
Warranties are non-transferable. The warranty applied to a product, on
purchase, is limited to the original purchaser.
10.0 Preventative Maintenance Program
To properly provide for the continued operation of your MGI Zip
Navigator, MGI has introduced its Preventative Maintenance Program
[PMP]. The PMP consists of work to be carried out by both the owner
and authorised service centres. To maintain the warranty of your MGI
Zip Navigator, it is essential that this work is carried out. If the work
carried out by the authorised Service Centre is to replace parts that
are part of the maintenance schedule, the owner will be charged for
the parts and labour. If the work to be carried out is covered under
warranty, MGI will bear the cost.
10.1 Cleaning Your Zip Navigator [See Maintenance Schedule]
For years of good operation, your Zip Navigator requires care and
attention:
• Keep your Zip Navigator clean by using a cloth with warm
water and a mild detergent.
• Do not hose down your Zip Navigator under any circumstance, as
the Zip Navigator has electronic components.
• Ensure that the seat stem bracket is free of sand and debris.
• Do not submerge your Zip Navigator, partially or fully as it will
damage the drive system and/or the electronics. The Zip Navigator
is designed to withstand wet weather (in conjunction with a Zip Rain
Cover [sold separately]).
• Clean the Zip Navigator battery base when the battery
is removed from the Zip Navigator.
• Regularly brush away sand/dirt from moving parts and toggles for
smooth operation.
10.2 Rear Wheel Axles Maintenance [See Maintenance Schedule]
The rear wheel stub axles need to be lubricated regularly. Remove the
rear wheels by depressing the spring clip and at the same time pull
off the wheel. Apply Petroleum Jelly or light grease to the stub axles.
Use a very small amount as the lubricant can attract sand. If you
play in sandy conditions you should clean the axle and re-lubricate
fortnightly. Once your cloth has dried out, please lightly coat the axle
with Petroleum Jelly.
MGI Zip Navigator User Manual 19
To Next Page
Loading...
