Page 9
induSENSOR, EDS
2.2 Structure
A coil is mounted inside the sealed rod, protected against environmental influences. The micro-electronics is
integrated in the sensor housing. A pressure-proof, stainless steel housing is available as an option. The sen-
sors are used for measuring lengths from 100 to 630 mm.
Electrical connection:
- Connector 4-pins, type Amphenol C164P compact (Model EDS-...-S...)
1
- Connector 7-pins, type Binder 712 (Model EDS-...- S ...7...)
- Connector 5-pins, CA02COM-E14S with bayonet connection (Model EDS-...-F...)
- Wire, axial (model EDS-...-Z...)
1) Previous model no longer available
To Next Page
Loading...
Need help?
General
