• Optionally remove: R308 (There is no contention here, but can represent a large load on the
signal.)
• Remove any SD/SDIO cards from the SD Card connector
caution: PCC will not work at the same time as Ethernet, SD Card, QTouch, and I
2
C on EXT1.
Info: Revert the steps to restore the original functionality. Use 0Ω resistors or solder blobs to
short strap.
5.5.2 Operation at Other Voltages
The SAM E54 Xplained Pro board is operated at 3.3V by default, but it also has the possibility of running
at lower voltages from an external supply. The EDBG is designed to run from a 3.3V supply and won't
work on other voltages, therefore all connections from the EDBG and the on board 3.3V regulator to the
ATSAME54P20A have to be removed.
To completely disconnect the EDBG and the on-board power supply from the ATSAME54P20A do the
following:
• Remove the two jumpers from the on-board 3-pin current measurement headers (J100 and J102),
and connect the two center pins (pin 2) together with a wire or an ammeter, as shown in Figure 5-7
• Remove R802, R803, R808, R809, R810, R811, R812, R813, R814, R815, R816, R817, R818,
R824, R825, R826, R827
• Optionally cut J101 to remove power to the on-board current measurement headers (J100 and
J102) from the on-board regulator
Figure 5-6 shows all components that have to be removed from the bottom side of the PCB for operation
at other voltages. To locate the other components, see the assembly drawing in the section above. When
the components are removed, the kit can be supplied with a desired voltage through the pins marked
3.3V (pin four) and GND (pin two) on the Xplained Pro power header. To program and debug the
ATSAME54P20A the 2x5 50mil Cortex debug connector has to be used with an external debugger.
Info: Operating the ATSAME54P20A on other voltages than 3.3V requires physical
modifications on the kit using a soldering iron and an external debugger for programming the
ATSAME54P20A. The on-board current measurement only works at 3.3V. The on-board LED is
selected for 3.3V operation, the light level at 1.8V operation is very low. To increase the emitted
light level the value of the series resistor can be lowered. The EDBG functionality can be
restored by re-soldering the removed components and soldering a 0Ω resistor over J101.
Caution: The voltage supplied through the power header is applied directly to the
ATSAME54P20A and the extension headers. Applying a voltage greater than 3.3V may damage
the board permanently.
SAM E54 Xplained Pro
© 2017 Microchip Technology Inc.
DS70005321A-page 37
To Next Page
Loading...
Need help?
General
