Microchip Technology SAM E54 Xplained Pro - Appendix; Getting Started with IAR

7. Appendix
7.1 Getting Started with IAR
IAR Embedded Workbench
®
for ARM
®
is a proprietary, high-efficiency compiler not based on GCC. The
programming and debugging of Xplained Pro kits are supported in IAR
™
Embedded Workbench for ARM
using the common CMSIS-DAP interface. Some initial settings have to be set up in the project to get
programming and debugging to work.
The following steps explain how to set up a project for programming and debugging:
1. Open the project that needs to be configured. Open the OPTIONS dialog for the project.
2. In the General Options category, select the Target tab. Select the "Device" for the project or the
"Core" of the device.
3. In the Debugger category, select the Setup tab. Select CMSIS DAP as the driver.
4. In the Debugger category, select the Download tab. Select the Use flash loader(s) option.
5. In the Debugger > CMSIS DAP category, select the Setup tab. Select System (default) as the
reset method.
6. In the category Debugger > CMSIS DAP, select the JTAG/SWD tab. Select SWD as the interface
and optionally select the SWD speed.
Figure 7-1. Select Target Device
SAM E54 Xplained Pro
© 2017 Microchip Technology Inc.
DS70005321A-page 40