3.3.8 SNMP
This device supports SNMP-management, which allows network administrators to
monitor and configure this device with SNMP software. To allow this device to be
managed via SNMP:
*. Select “enable” in the drop list.
*. Specify a trap IP. A trap IP is the destination port for sending trap information,
which is usually the IP address of network administrators.
*. Fill in a name in the “Community Get” column, which is the password for
accessing MIB with read-only authority.
*. Fill in a name in the “Community Set” column, which is the password for
accessing MIB with read and write authority.
20
To Next Page
Loading...
