3.3.4 Aggregation/ Trunk Configuration
To set up the Port trunk groups, put the ports number into the same Aggregation
group. There are eight groups to choose. Don’t forget to click the “Apply” to save
the setting.
There are three aggregation modes for you to setup, SMAC, DMAC, and XOR.
SMAC mode selects the path of packets according to source MAC while DMAC
mode selects path according to destination MAC. XOR mode calculates the result of
DMAC and SMAC mode to decide the path of pack
3.3.5 Quality of Service
QoS enhances the communication quality by giving different precedence to
classified packets. This switch provides port-based, tag-based and DSCP QoS
modes:
16
To Next Page
Loading...
