EasyManuals Logo

Micronics D5CUB PCI User Manual

Default Icon
80 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #24 background imageLoading...
Page #24 background image
D5CUB System Board Manual
Installing the D5CUB
Installation of the D5CUB system board depends on the
type of case you use. The D5CUB is an integrated baby AT
size system board and may be installed into most cases.
NOTE: If you are unfamiliar with installing a system board,
Micronics highly recommends that you read the computer
user’s manual or contact your dealer’s technical support
department.
Tools Required
Micronics recommends using the following tools to install
the D5CUB:
Small Phillips screwdriver
Tweezers or a pair of needle-nose pliers
Tray (to hold loose screws)
Equipment Required
Micronics recommends using the following equipment
with the D5CUB for a typical configuration:
Chassis with standard hardware.
A high quality power supply capable of providing
continuous power within a 5 volt range.
PS/2 mouse and standard AT style keyboard.
Eight ohm speaker.
Standard ribbon cables for internal connections.
Standard power cord (grounded).
Heat sink with cooling fan for CPU (required).
Section 3: Installing the D5CUB
22

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Micronics D5CUB PCI and is the answer not in the manual?

Micronics D5CUB PCI Specifications

General IconGeneral
BrandMicronics
ModelD5CUB PCI
CategoryMotherboard
LanguageEnglish