Micronics D5CUB PCI User Manual

D5CUB System Board Manual
Section 3: Installing the D5CUB
26
Installing the SIMMs
To install the SIMMs, locate the memory banks on the
system board and perform the following steps:
1. Hold the SIMM so that the notched edge is aligned
with the notch on the SIMM socket (Figure 3-1).
2. Insert the SIMM at a 45 degree angle.
3. Gently push the SIMM into an upright position until
it locks into place (past the release tabs).
Figure 3-1: Installing a 72-Pin SIMM
Removing SIMMs
To remove SIMMs, follow the steps below:
1. With both thumbs (or fingers), press the release tabs
away from the socket.
2. With the SIMM free from the release tabs, lift the
module up and place in an anti-static bag or package.

Micronics D5CUB PCI Specifications

General

Brand	Micronics
Model	D5CUB PCI
Category	Motherboard
Language	English