7. USE OF BATTERIES
Open the recorder. Insert the battery in the battery compartment (9), respecting the polarity
as marked in the compartment.
BATTERIES
SpiderView is powered by one AA 1.5 V battery (lithium or alkaline).
A new lithium battery will last between one and seven consecutive days of recording,
depending on the brand of battery, the recording quality mode, and the number of channels.
A new alkaline battery will last between one and four consecutive days of recording,
depending on the brand of battery, the recording quality mode, and the number of channels.
After using the device for one recording, it is recommended to keep the battery inside the
device for the next usage. If the voltage is not sufficient for another 24h recording, a warning
message will appear after switching on the device.
NOTE: If SpiderView is switched on when the battery is low, the duration of the recording
will be one day only (24h), regardless of the programmed time.
RECHARGEABLE BATTERIES
For 24-hour recordings SpiderView may also be powered by a re-chargeable battery with a
minimum capacity of 1500 mA/h.
We recommend that you read carefully through the instructions that came with the batteries.
NOTE: Use a suitable charging device to recharge the batteries and follow the battery
manufacturer's instructions.
INTERNAL MEMORY BATTERY
SpiderView contains an internal battery that ensures the maintenance of the system’s date
and time and other parameters (contrast, recording quality mode) for about a week.
The internal battery recharges automatically during the daily usage of the recorder.
WARNING:
When the recorder is not used, it is recommended that the 1.5 V battery power supply not
be removed, in order to constantly guarantee the recharge of the internal memory battery. If
the internal memory battery is completely charged, the system’s parameters will be
maintained without the 1.5 V battery power supply for approximately one week.
7.1.
7.2.
7.3.
7. USE OF BATTERIES
14 SpiderView – UA10709B
To Next Page
Loading...