Advanced Concepts
FrontRunner™
2
v4.1.3, April 2012 Visionscape FrontRunner™ User’s Manual 2-17
• Select Folder — Displays the Browse For Folder dialog box, which
allows you to specify where images and reports are saved. Use the
New Folder button to create a new folder for images and reports.
• With Graphics / Without Graphics — Specifies whether or not you
want to include tool graphics with the saved images.
• Save None / Save All Images / Save Failed Images / Save Passed
Images — Specifies what images you want to save (if any).
• Show Tool Graphics — By default, FrontRunner™ displays the tool
graphics with the captured image.
• All Images / Failed Images — Specifies what kind of images
FrontRunner™ should display.
Note: Any change you make apply to all snapshots in the Inspection.
• Freeze This / Freeze Next Failed / Freeze Last Failed — Specifies
which image FrontRunner™ should freeze.
Note: Any change you make apply to all snapshots in the Inspection.
• Maximum Rate w/drops / ... / Every Image (no drops) — Specifies the
rate at which FrontRunner™ should display images.
Note: Any change you make apply to all snapshots in the Inspection.
When the image rate is set to Maximum Rate w/Drops or any of the 2,
4, or 8 per second rates, priority is given to the running of the
Inspection such that images are sent only when there is enough idle
time to do so (for example, while waiting for the next image to be
acquired from the camera). If there is little or no idle time, then the
Image view may refresh very slowly and appear to either show
always the same image or not refresh any image at all. This can
happen in the most extreme cases in full pipeline with no idle time left;
in this case, the display will freeze for long periods of time. If seeing a
“live” image is required, then the avp should be designed to allow for
some idle time while still maintaining the inspection rate required by
the external triggering source. A special case of this are Software
To Next Page
Loading...
