Chapter 2 FrontRunner™
2-32 Visionscape FrontRunner™ User’s Manual v4.1.3, April 2012
Matrix with 16 rows and 16 columns until you untrain the tool. Use the
following procedure to untrain a Data Matrix tool:
a. Highlight the Data Matrix tool in the left window pane.
b. Click Untrain. Now, you can train the tool to read a new part, or
leave it “opened up” to read any Data Matrix.
• Run Current Step then Jump to Next Step / Jump to Previous Step —
Use these buttons to walk through the Setup List and train/execute
each trainable tool.
• Tryout Program on PC in a Loop — Runs the Job on the PC until you
click this button again.
• Tryout Program on PC Once and then Stop — Runs the Job on the
PC once and then stops.
• Tryout Current Step on PC — Runs the current step on the PC.
• Acquire New Image — Acquires a new image.
• Live Video — Allows you to see exactly what the camera is seeing in
real time. This makes it easier for you to adjust focus and lighting to
get the best image possible.
Note: If the camera acquisition is triggered in the avp, Live Video will
be triggered also. This behavior can be turned off in TryOut mode
only from the TryOut Options dialog box in the case where triggers
cannot be fed to the system during Live Video.
• Zoom In — Makes the image larger.
• Zoom Out — Makes the image smaller.
• Zoom To Fit Window — Sizes the image to fit the window.
• Zoom 1:1 — Displays the image in its actual size.
• Settings — Contains the following tabs:
– Edit — FrontRunner™ allows you to specify what action(s) will
take place after you change a step or during tryout.
To Next Page
Loading...
