Chapter 2 FrontRunner™
2-42 Visionscape FrontRunner™ User’s Manual v4.1.3, April 2012
Button Descriptions
• Display Extended Results — This LED turns green if the inspection
passed, and red if the inspection failed.
• Show results in World (calibrated) space — Shows results in a world
coordinate versus a pixel coordinate system.
• Show all statistics in World (calibrated) space — Shows statistics in a
world coordinate versus a pixel coordinate system.
• Reset all counters and statistics — Resets both the counters and the
statistics to zero.
• Reset inspection counters — Resets only the counters to zero.
• Reset all statistics — Resets only the statistics to zero.
• Copy result data to Clipboard — Copies the data to the Clipboard as
tab-delimited text.
Statistics
• Cycle Counts — Displays the total number of inspection cycles so far,
as well as the number of passed and failed inspections. The “PartQ”
column is only relevant if you have activated the Part Queue (see
Chapter 4, “The Part Queue”) in your inspection. It displays the
current number of entries in the Queue, and the maximum size of the
Queue. So, if you’ve set the size of the Queue to be 20, and there are
currently 5 entries in it, then “5/20” is displayed.
• Timing — Displays timing information on the last inspection cycle. All
times are in milliseconds.
– Cycle — Time between triggers.
– Cycle Worst — Worst time between triggers.
– Process — Actual time spent processing the image. This will not
include image acquisition time in a standard triggered Job.
– Draw — Time spent rendering graphics.
– PPM — Number of parts per minute.
To Next Page
Loading...
