Microscan Visionscape FrontRunner - Page 75

Menus You’ll See in FrontRunner™
FrontRunner™
2
v4.1.3, April 2012 Visionscape FrontRunner™ User’s Manual 2-53
• Dump Job to Text File — Creates a text file containing a listing of
each loaded Vision System. After you select this menu item,
FrontRunner™ displays the Save Vision System Tree as Text dialog
box. Specify a name for the text file and click Save.
• Show Job Info — Displays the header information for a Job:
–Job name
– Version of the software used to create the Job
– Total objects
– Total steps
– File type
– Digitizer type
• Configure Device — Displays a dialog box containing tabs for the
following:
– Serial Ports — The COM ports are indexed to the target
platform’s available UARTs. The default is NONE, which will
construct the output string datum but not transmit the result on
any port.
After you select Configure Device, FrontRunner™ displays the
Configure dialog box. Configure the various parameters, then
click Apply and then OK.
Note: For the VS-1 Smart Cameras, the serial ports are named
RS232-<Number>. For example, the VS-1 Smart Camera single
serial port is called RS232-1.
– TCP Ports — The TCP ports are indexed according to the port
settings specified in the Configure Device dialog box. For
example, if Starting Serial TCP Port is 49211, then selecting
TCP1 will output on port 49211, TCP2 on port 49212, etc. The
default is NONE, which will construct the output string datum but
not transmit the result on any port.
After you select Configure Device, FrontRunner™ displays the
Configure dialog box. Click the TCP Ports tab. Type in the
appropriate information, then click Apply and then OK.