Chapter 3 Camera Calibration
3-4 Visionscape FrontRunner™ User’s Manual v4.1.3, April 2012
9. Under “Select the Camera to Calibrate”, highlight (to select) a
camera.
– If you select “I Want to Calibrate a Particular Camera, and apply it
to all Snapshots that use that Camera”, “Select the Camera to
Calibrate” will list the cameras that are being used in the current
Job.
– If you select “I Want to Calibrate Each Snapshot Individually”,
then each Inspection step is listed, with each of its Snapshots
underneath.
10. Click Next.
FrontRunner™ displays the Calibration screen shown in Figure 3–3.
To Next Page
Loading...
