Need help?Do you have a question about the Microsemi SyncServer S200 and is the answer not in the manual?
Step-by-step guide for initial SyncServer configuration using recommended tasks.
Provides procedures for safely shutting down the SyncServer via keypad or web interface.
Lists the key features and benefits of the SyncServer, detailing its capabilities.
Covers login, user names, passwords, and recovery features for the web interface.
Details Ethernet port settings, IP configuration, and port bonding.
Covers NTP associations, MD5 keys, and override behavior settings.
Manages time zones, hardware clocks, holdover, and Sysplex settings.
Covers unpacking, rack mounting, grounding, and power connections.
Details GPS antenna site selection, installation, operation modes, and verification.
Guides software upgrades, NTP server setup, password recovery, and network port configuration.
Addresses password, web interface, alarm, and NTP client issues.
Covers backup/restore, factory reset, SNMP, transferring configs, and battery replacement.
General| Model | SyncServer S200 |
|---|---|
| Category | Server |
| Form Factor | 1U Rackmount |
| Type | Time Server |
| Time Synchronization Protocols | NTP, PTP |
| Input Power | 100-240 VAC |
| Network Interface | Gigabit Ethernet |
| GNSS Receiver | GPS, GLONASS, Galileo, BeiDou |
| Operating Temperature | 0°C to 50°C |
| Dimensions | 1U rack mount |
| Outputs | 1PPS, 10 MHz, IRIG-B |
To Next Page
