Microsemi SyncServer S200 - Logs Config

ADMIN
System Health Alarm Major X X X X
System Up/Down Alarm Minor X X X X
System Authentication Alarm Notify X X
Timing No Source Alarm Major X X X X
Timing GPS Source Alarm (not in S250i) Major X X X X
Timing IRIG-B Source Alarm (not in S200) Notify X X
Timing PPS Source Alarm (not in S200) Notify X X
Timing 10 MHz Source Alarm (not in S200) Notify X X
Timing GPS Antenna Short Alarm (not in
S250i)
Major X X X X
Timing GPS Antenna Open Alarm (not in
S250i)
Major X X X X
Timing Oscillator DAC Range Alarm Notify X
Timing Rubidium Lock Alarm (Rb Models
Only)
Notify X
Timing Oscillator Unlock Alarm Notify X
Timing Source Change Alarm Notify X
Timing Source Lower Accuracy Input Alarm Notify X
Timing PLL Unlock Alarm Notify X X
Timing Quality 1e-6 Alarm Notify X X
Timing Quality 1e-5 Alarm Notify X X
Timing Quality 1e-4 Alarm Notify X X
Timing Quality 1e-3 Alarm Notify X X
Timing Leap Event Alarm Notify X X
LAN1 Link Alarm Major X X
LAN2 Link Alarm Notify X X
LAN3 Link Alarm Notify X X
System Reset Default Config Alarm Major X
LogsConfig
Logs Config - Default Settings
997-01520-02 Rev. G2.......................................................................... Page 175