To Next PageTo Next Page
Need help?Do you have a question about the Microsemi SyncServer S600 and is the answer not in the manual?
Discusses inherent security features and optional advanced authentication services.
Details AC and DC power connections, and frame ground connections.
Explains how to configure the SyncServer via keypad, web interface, or CLI.
Describes how to control the SyncServer using the Command Line Interface.
Explains how the SyncServer uses alarms to notify of issues and how they are indicated.
Provides initial information and considerations before installing the SyncServer S6x0.
Provides guidelines for installing the SyncServer S6x0 chassis into a rack.
Details how to make ground and power connections for the SyncServer S6x0.
Details GNSS input, NTP connections, and 1PPS output.
Provides instructions for connecting the GNSS antenna.
Details how to apply power to the SyncServer S6x0.
Provides access to windows for Ethernet, SNMP, SNMP Trap configuration, and Ping.
Provides access to windows for configuring NTP, viewing NTP status, and NTP associations.
Provides access to configure security settings for users, access control, services, HTTPS, SSH, etc.
Provides access to windows for general configuration and software updates.
Provides access to windows for system log and events log configuration.
Provides an alphabetical listing and details of all CLI commands.
CLI command to set the system time.
CLI command to replace current configuration with factory defaults.
CLI function to view alarm status and indicators.
CLI command to shut down the operating system as a preparatory step before power-off.
CLI command to set address mode (DHCP/Static) and provision IP parameters.
CLI command to halt current operation and reboot the SyncServer S6x0.
Describes four ways to bring the SyncServer S6x0 online.
Explains how to add, edit, or delete user names in the access list via Web GUI.
Details configuration of Ethernet ports, including auto-negotiation and IP version.
Describes how to acquire frequency and TOD alignment using external references.
Details how to set satellite position parameters for GNSS reference.
Explains how LAN2-LAN6 ports can be configured as PTP Client inputs.
Explains how to create and modify NTP associations with different roles.
Covers NTPd symmetric keys and autokey server/client configurations.
Suggests using LEDs and System Messages for troubleshooting.
Details how to upgrade the SyncServer S6x0 firmware using the web interface.
General| Model | SyncServer S600 |
|---|---|
| Form Factor | 1U Rackmount |
| Type | NTP Time Server |
| Time Synchronization Protocols | NTP, PTP |
| Network Interfaces | 10/100/1000Base-T Ethernet |
| GNSS Receiver | GPS, GLONASS, BeiDou, Galileo |
| Power Supply | 100-240 VAC, 50/60 Hz |
| Operating Temperature | 0°C to 50°C (32°F to 122°F) |
| Protocols | SNMP, SSH, HTTPS |
| NTP Time Server Capacity | >10, 000 NTP requests per second |
