Microsemi SyncServer S600 - Factory Defaults; Network; Network > Ethernet Parameters; Network > SNMP Parameters

290 SyncServer 600 Series User’s Guide 098-00720-000 Revision D1 – February, 2018
Appendix B Specifications and Factory Defaults
Factory Defaults
Factory Defaults
Network
Table B-30. Network > Ethernet Parameters
Description Default Value Value Range
Speed Auto Auto | Full_100 | Full_1000
IPv4 IPv4
uncheck/static
IPv4 uncheck | IPv4 check/DHCP | IPv4
check/Static
IP6v IPv6 uncheck/
autoconfig /static
IPv6 uncheck | IPv6 check/ Autoconfig
uncheck/static |
IPv6 check/Autoconfig uncheck /DHCP |
IPv6 check/Autoconfig check/static |
IPv6 check/Autoconfig check/DHCP
Address (IPv4) Blank (no value) [ <ipv4_address> ]
Subnet (IPv4) Blank (no value) [ <ipv4_address> ]
Gateway (IPv4) Blank (no value) [ <ipv4_address> ]
Address (IPv6) Blank (no value) [ <ipv6_address> ]
Subnet (IPv6) Blank (no value) [ <ipv6_address> ]
Gateway (IPv6) Blank (no value) [ <ipv6_address> ]
Table B-31. Network > SNMP Parameters
Description Default Value Value Range
sysLocation unknown [ <printable ASCII> ], 1 - 49 chars
Read Community comm [ <printable ASCII> ], 1 - 49 chars
SysName SyncServer [ <printable ASCII> ], 1 - 49 chars
Write Community Comm1 [ <printable ASCII> ], 1 - 49 chars
sysContact admin@
localhost
[ <printable ASCII> ], 1 - 49 chars
Name (v3 User) Blank (no val [ <printable ASCII> ], 1 - 49 chars