Microsemi SyncServer S600 - F50 - GPS Receiver LLA;XYZ Position

098-00720-000 Revision D1 – February, 2018 SyncServer 600 Series User’s Guide 155
Chapter 5
SyncServer S6x0 CLI Command Set
F50 - GPS Receiver LLA/XYZ Position
GPS Receiver LLA/XYZ Position
Use function
F50 to display the current GPS position, as well as the following:
 Select the positional coordinate system, Latitude Longitude Altitude (LLA) or XYZ
(Earth- Centered, Earth-Fixed XYZ coordinates).
 If LLA is selected, Altitude Mode shows the elevation in given meters.
Use the following format to display the current position of the GPS receiver in LLA
coordinates:
F50<S>B<N><SEP>LLA<CR>
SyncServer S6x0 responds with the coordinate information in the following format:
F50<S>B<N><SIGN><S><DEG>d<MIN>'<SEC>"<S><SIGN><S><DEG>d<MIN>
'<SEC>"<S><ALT><UNITS><CR><LF>
where:
 F50 = Function 50
 <S> = ASCII space character one or more.
 B = ASCII letter to denote Option Bay number follows
 <N> = Option Bay Number, 1.
 <SEP> = Separator
 LLA = LLA mode
 <CR> = carriage return character.
 <SIGN> = N or S for latitude; E or W for longitude;
 - for negative altitude and <S> or + for positive altitude.
 <DEG> = two-digit degrees for latitude or three-digit degrees for longitude.
 d = ASCII character d
 <MIN> = two-digit minutes.
 ' = ASCII character '
 <SEC> = two-digit seconds + 1 digit 10ths of seconds.
 " = ASCII character "
 <ALT> = altitude in meter
 <UNITS> = unit of altitude, ¡§m¡¦ for meters
 <LF> = line feed character.
For example, to display the LLA coordinates of the antenna, enter: