098-00720-000 Revision D1 – February, 2018 SyncServer 600 Series User’s Guide 179
Chapter 6 Provisioning
Managing the User Access List
3. Start the terminal emulation software and press Enter. The system prompt
should appear. If it does not, recheck each step in this procedure.
4. Type your user name and press Enter. The system prompts for a password.
5. Type your password and press Enter. The system prompt appears.
Managing the User Access List
When you are logged in with the Web GUI, you can add, edit, or delete user names
in the user access list. The user list can contain up to 15 names (in addition to
“admin”). Users are required to enter a user name and password to log in to the
system. All Users and Admin have the same privileges.
Use the procedures in this section to manage user access to the SyncServer S6x0.
Logging In
Use the following procedure to log in to the system at the admin level.
Note: The default user name is “admin”. The default password is:
Microsemi.
Note: The default user name is “admin” and the default password is:
Microsemi .
To avoid unauthorized access, you should change the default
password.
To Next Page
Loading...
