Microsemi SyncServer S600 - Provisioning Outputs; Configuring Network Timing Services

098-00720-000 Revision D1 – February, 2018 SyncServer 600 Series User’s Guide 209
Chapter 6 Provisioning
Provisioning Outputs
Add NTP Server Association using Autokey Authentication
Use the Network Timing > NTPd Config page to add NTP server associations where
the SyncServer is Autokey Client..
Provisioning Outputs
Configuring Network Timing Services
The form Network Timing„> NTPr/PTP Config) supports generalized configuration of
network timing services. The concept is that the ability to create and retain
definitions for specific services, independently of the connection method, provides a
useful way to aggregate within the S6x0 all network timing services that are of
interest for that particular unit. As added services are provided in future releases,
this form will evolve to support extended service capabilities. Up to 10 services
(rows) can be created.
Table 6-15. Configure NTP Autokey Client
Method Steps Notes
Web Interface Network Timing -> NTPd Config
1. Add a Role of Server.
2. Select 'Auto' from Symmetric
pull-down menu
3. Optional step:
Check 'Prefer' for newly added
NTPd server association and
Uncheck 'Prefer' for Hardware
Reference Clock, so that newly
added NTPd will be selected as
input reference over GNSS.
4. Click the Save button.
5. Click the Restart button to make
any changes take effect.
CLI n/a n/a
Front Panel n/a n/a