48 SyncServer 600 Series User’s Guide 098-00720-000 Revision D1 – February, 2018
Chapter 2 Installing
Getting Started
Getting Started
Before you begin to install the SyncServer S6x0, review the information in this
section.
If you encounter any difficulties during the installation process, contact Microsemi
Frequency and Time Division (FTD) Services and Support. See Contacting
Technical Support, on page 248 for telephone numbers. Contact Microsemi FTD
Services and Support for technical information. Contact Customer Service for
information about your order, RMAs, and other information.
Security Considerations for SyncServer S6x0 Installation
The SyncServer S6x0 should be installed in a physically secure and restricted
location.
Whenever possible, the SyncServer S6x0's Ethernet ports should be installed
behind the company's firewall to prevent public access.
Site Survey
The SyncServer S6x0 can be installed in a wide variety of locations.
Before you begin installation, determine the chassis location, ensure the
appropriate power source is available (120/240 VAC), and ensure that the
equipment rack is properly grounded.
The SyncServer S6x0 is designed to mount in a 19-inch (48 cm) rack, occupies 1.75
in (4.5 cm, 1 RU) of vertical rack space, and has a depth of 15” (38.1 cm).
The SyncServer S6x0 is to be installed into a rack. The AC power connection is to
be made to a 120 or 240 VAC power receptacle following local codes and
requirements. An external Surge Protective Device is required to be used with the
AC version of the SyncServer S6x0.
Environmental Requirements
To prevent the unit from malfunctioning or interfering with other equipment, install
and operate the unit according to the following guidelines:
Operating temperature: –40Fto 149F (–20 C to 65C) for SyncServer S6x0
with quartz oscillator (standard or OCXO); 23Fto 131F (–5 C to 55C) for
SyncServer S6x0 with Rubidium oscillator.
Operating Humidity: 5% to 95% RH, maximum, w/condensation
To Next Page
Loading...
