Microsemi SyncServer S600 - Syncserver S6 X0 Part Numbers; System and Accessory Part Numbers; Upgrading Firmware

098-00720-000 Revision D1 – February, 2018 SyncServer 600 Series User’s Guide 241
Chapter 7 Maintenance, Troubleshooting & Part Numbers
SyncServer S6x0 Part Numbers
SyncServer S6x0 Part Numbers
The following sections provide part numbers for the system, accessories, and
GNSS antenna kits.
System and Accessory Part Numbers
This section provides part numbers and descriptions for the system and accessories
available for the SyncServer S6x0. See Table 7-4 for Quickship part numbers. See
Table 7-5 for S600 Build to Order part numbers. See Table 7-6 for S600 Build to
Order part numbers. See Table 7-7 for accessories.
Table 7-3. Upgrading Firmware
Method Steps Notes
Web Interface Admin > Upgrade
1. Navigate to the location of the
authorization file and select it.
2. Navigate to the location of the
upgrade file and select it.
3. Click the Install button.
CLI n/a n/a
Front Panel n/a n/a
Note: If "upgrading" from revision 2.0 or higher to releases 1.0 or 1.1,
then the system will set configuration to factory default values.
Note: Configuration changes made after the upgrade but before the
reboot will not be available after the reboot.
Note: If the all-packets limit on LAN1 has been reduced on the
Security > Packet Monitoring page, then it is recommended that the
limit be temporarily increased back to the default value of 13000
packets/second. Otherwise, the file upload will be very slow and may
timeout.