Microsemi SyncServer S600 - Ntp; NTP > NTP Configuration Parameters; Ptp; PTP > PTP Configuration Parameters for Enterprise Profile

292 SyncServer 600 Series User’s Guide 098-00720-000 Revision D1 – February, 2018
Appendix B Specifications and Factory Defaults
Factory Defaults
NTP
PTP
Table B-33. NTP > NTP Configuration Parameters
Description Default Value Value Range
Role Server Server | Peer | Broadcast
Address Blank
(no value)
[ <IPv4_address> | <IPv6_address> |
<dns_ name> ]
Port Default LAN1 | LAN2 | LAN3 | LAN4
Prefer uncheck uncheck | check
Burst N/A N/A | Burst | iBurst | Both
MinPoll Default Power-of-2 times in seconds range:
default | 16 | 32 | 64 | … | 65536
MinPoll cannot be > MaxPoll
MaxPoll Default Power-of-2 times in seconds range:
default | 16 | 32 | 64 | … | 65536
MaxPoll cannot be < MinPoll
Symmeteric None None | Auto | 1 | 2 | … | 17 | 18 | 19 | 20
Table B-34. PTP > PTP Configuration Parameters for Enterprise Profile
Description Default Value Value Range
Domain 0 0 to 127
Two-Step Disabled Disabled | Enabled
Priority 1 128 0 to 255
Priority 2 128 0 to 255
Announce Interval 0 0 (fixed)
Sync Interval 0 -7 to 7
Delay Interval 3 -7 to 7
Announce Timeout 3 3 (fixed)
Diffserv Code 0 0 to 63
Offset Scaled Log Variance
Override
Not checked Not checked or checked