Microsemi SyncServer S600 - Chapter 6 Provisioning

098-00720-000 Revision D1 – February, 2018 SyncServer 600 Series User’s Guide 175
Chapter 6 Provisioning
This chapter describes the procedures for provisioning the SyncServer S6x0. Use
the procedures in this chapter after you have installed and powered up the
SyncServer S6x0 (see Chapter 2, Installing).
In This Chapter
 Establishing a Connection to the SyncServer S6x0
 Managing the User Access List
 Provisioning Ethernet Port
 Provisioning Input References
– Setting GNSS Parameters
– Provisioning IRIG Inputs on Timing I/O Module
– Provisioning Sine Wave Inputs on Timing I/O Module
– Provisioning PTP Client Input
– General Behavior Associated with Manual Entry
 Provisioning NTP Associations
 Provisioning NTP Security
– NTPd Symmetric Keys
– NTPd Autokey Server
– NTP Autokey Client
– Add NTP Server Association using Autokey Authentication
 Provisioning Outputs
– Configuring Network Timing Services
– Mapping a Network Timing Service to a LAN Port
– Observing Status of Network Timing Services
– Monitoring Network Packets
– Provisioning the PTP Server Output
– Provisioning the Serial Timing Output
– Provisioning Outputs on Timing I/O Module
 Provisioning Alarms
 Saving and Restoring Provisioning Data
 Provisioning for SNMP