166 SyncServer 600 Series User’s Guide 098-00720-000 Revision D1 – February, 2018
Chapter 5
SyncServer S6x0 CLI Command Set
show ip
Use this command to display the current IP settings for all LAN ports.
Command Syntax:
show ip config
The information displayed is consistent with the content shown in the Web Interface
(Dashboard>Network>Ethernet).
Example:
SyncServer> show ip config
Response:
Eth port config
---------------------------------------------------------
|Port|Speed |IPVersion |IPv4Mode|IPv6Mode|AutoConfig|
|----|----------|----------|--------|--------|----------|
|LAN1|AUTO |ipv4 |DHCP |STATIC |enable |
|....|..........|..........|........|........|..........|
|LAN2|AUTO |ipv4 |STATIC |STATIC |enable |
|....|..........|..........|........|........|..........|
|LAN3|AUTO |ipv4_ipv6 |STATIC |STATIC |enable |
|....|..........|..........|........|........|..........|
|LAN4|AUTO |ipv4_ipv6 |DHCP |DHCP |disable |
---------------------------------------------------------
IPv4 config
---------------------------------------------------------
|Port|Address |Subnet Mask |Gateway |
|----|----------------|----------------|----------------|
|LAN1|192.168.1.100 |255.255.255.0 |192.168.1.1 |
|....|................|................|................|
|LAN2|192.168.99.7 |255.255.255.0 |192.168.99.1 |
|....|................|................|................|
|LAN3|192.168.1.99 |255.255.255.0 |192.168.1.1 |
|....|................|................|................|
|LAN4|192.168.4.100 |255.255.255.0 |192.168.4.1 |
---------------------------------------------------------
IPv6 config
-----------------------------------------------------------------------------
|Port|Address |Pref|Gateway |
|----|--------------------------------|----|--------------------------------|
|LAN1| |0 | |
|....|................................|....|................................|
|LAN2| |0 | |
To Next Page
Loading...
