Microsemi SyncServer S600 - Setting Ethernet Port Parameters

184 SyncServer 600 Series User’s Guide 098-00720-000 Revision D1 – February, 2018
Chapter 6 Provisioning
Provisioning the Ethernet Ports
Table 6-5. Setting Ethernet Port Parameters
Method Steps Notes
Web Interface Network > Ethernet
1. Select the speed with Speed dropdown
box for the desired port
2. Select the IP address type by clicking
on the IPv4 check box
3. Enter the IP address using the
dot-decimal notation format
xxx.xxx.xxx.xxx
4. Enter the Subnet mask using the
dot-decimal notation format
xxx.xxx.xxx.xxx. For IPv6, enter the
prefix length.
5. Enter the Gateway address using the
dot-decimal notation format
xxx.xxx.xxx.xxx.
6. Click the Apply button.
CLI
set ip ip-address lan {1|2|3|4|5|6}
ipv4 address <addrv4_value> netmask
<maskv4_value> gateway
<gatewayv4_value>
set ip address-mode lan{1|2|3|4}
{ipv4|ipv6} dhcp
Front Panel Menu button
Select “1) LAN1”
Select “1. Configure”
Select “1) IPv4” or “2) IPv6 (DHCPv6)
If IPv4, select Addressing Type “1) Static
Addr” or “2) DHCP”
If IPv4 Static Addr,
 enter IPv4 address and press Enter
button
 enter netmask and press Enter button
enter gateway and press Enter button
Can only be used to
set parameters for
LAN1.