Microsemi SyncServer S600 - References; References > GNSS Configuration Parameters; Security; Security > Users Parameters

294 SyncServer 600 Series User’s Guide 098-00720-000 Revision D1 – February, 2018
Appendix B Specifications and Factory Defaults
Factory Defaults
References
Security
Table B-37. References > GNSS Configuration Parameters
Description Default Value Value Range
Elevation Mask 5 5 to 60 degrees
Step size is 1 deg
Mode Survey Survey | Position Hold
Latitude (for Position Hold) N 0:0:0.000 Ndd:mm:ss.ss or
Sdd:mm:ss.sss
0 to 90 degrees
Longitude (for Position Hold) W 0:0:0.000 Eddd:mm:ss.ss or
Wddd:mm:ss.sss
0 to 180 degrees
Altitude (for Position Hold) 0.0 m -1000.0 to +12000.0 m
Antenna Cable Delay 0 0 to 10000 ns
GNSS Receiver Reset unchecked checked | unchecked
Table B-38. Security > Users Parameters
Description Default Value Value Range
User new user new user | admin
Delete Selected User checked not checked | checked
New Username Blank (no value)
Only admin user
is retained.
a-z, 0-9, _, 1 – 34 chars,
first character must be a
lowercase alpha character
(not underscore or number)