098-00720-000 Revision D1 – February, 2018 SyncServer 600 Series User’s Guide 169
Chapter 5
SyncServer S6x0 CLI Command Set
set nena active
Use this command to enable the NENA response mode on this connection.
Command Syntax:
set nena active
Example:
SyncServer>set nena active
Response:
NENA response active: CR to trigger, ctrl-c to deactivate
2016 349 07:40:19 S+00
2016 349 07:40:21 S+00
2016 349 07:40:22 S+00
2016 349 07:40:22 S+00
2016 349 07:40:23 S+00
SyncServer >
To Next Page
Loading...
