180 SyncServer 600 Series User’s Guide 098-00720-000 Revision D1 – February, 2018
Chapter 6 Provisioning
Managing the User Access List
Adding a User
Use the following methods to add a user to the system access list.
Table 6-2. Adding a New User
Method Steps Notes
Web Interface Security > Users
1. Enter New Username
2. Enter New Password
3. Retype New Password
4. Use radio buttons to select the desired
type of password recovery question
5. Enter Answer to password recovery
question
6. Enter email address of user for
password recovery communication
7. Enter SMTP gateway IPv4 address for
SyncServer
8. Send Test Email.
9. Click the Apply button
CLI n/a
Front Panel n/a
Note: The User name can only have alphanumeric characters,
hyphen, and underline, with a maximum of 34 characters. Mixed
upper-case and lower-case alphabetic characters in User names are
not allowed for firmware versions 2.1 or later. The first character must
be a lowercase alpha character.
abcdefghijklmnopqrstuvwxyz
ABCDEFGHIJKLMNOPQRSTUVWXYZ
0123456789
-_
There is a maximum of 16 users, including admin user.
To Next Page
Loading...
