098-00720-000 Revision D1 – February, 2018 SyncServer 600 Series User’s Guide 163
Chapter 5
SyncServer S6x0 CLI Command Set
halt system
Use this command to shut down the operating system as a preparatory step before
power-off. This command does not reboot the system.
halt system
The behavior of this command is the same as using the Web GUI to perform a Halt
(Dashboard>Security>Services).
Example 1:
If using via serial connection to console port:
SyncServer> halt system
The system is being HALTED NOW
.............................
<now numerious messages will be received as processes are stopped>
reboot: System halted
Example 2:
If using SSH session:
S650> halt system
The system is being shutdown now
The system can be powered off in 60 seconds
...........................................
SyncServer>
The connection is lost and on the front panel the following message appears:
System shutting down...
The system can be powered
off after 60 seconds.
At this point SyncServer S6x0 must be re-powered for further operation.
To Next Page
Loading...
