Microsemi SyncServer S600 - Configure NTP Autokey Client; NTP Autokey Client

208 SyncServer 600 Series User’s Guide 098-00720-000 Revision D1 – February, 2018
Chapter 6 Provisioning
Provisioning NTP Security
NTP Autokey Client
Use the Security > NTP - Autokey Client page to manage (add or remove) Autokey
keys for NTP associations where the SyncServer is an NTP client..
Note: Hostname of Autokey Server and Autokey client must be
different. Use the
Admin - General Configuration Window to set
hostname..
Table 6-14. Configure NTP Autokey Client
Method Steps Notes
Web Interface Security > NTPd Autokey Client
1. Browse to locate the Group Key
File from a secure location.
2. Click the Install button to save the
AutoKey Client File to the
SyncServer.
3. Click the Generate button to
create the key file.
4. Click the Restart button to make
any changes take effect.
5.
Install IFF Group Key File
While the NTP daemon
restarts, its services are
temporarily unavailable,
and it generates the
following alarm events:
NTP Stratum Change,
NTP System Peer
Change, NTP Leap
Change.
CLI n/a n/a
Front Panel n/a n/a