Microsemi SyncServer S600 - reboot system

098-00720-000 Revision D1 – February, 2018 SyncServer 600 Series User’s Guide 171
Chapter 5
SyncServer S6x0 CLI Command Set
reboot system
This command halts current operation, then reboots the SyncServer S6x0. Except
for no loss of power, this is functionally equivalent to power-up of the SyncServer
S6x0.
reboot system
The behavior of this command is the same as using the Web GUI to perform a
Reboot (Dashboard>Security>Services).
Example 1:
If using console port serial connection:
S650> reboot system
Response:
The system is going down for REBOOT NOW!
........................................
SyncServer login:
Example 2:
If using SSH session:
S650> reboot system
Response 2:
The system is going down for REBOOT NOW!
........................................
The connection will be lost after the REBOOT NOW! message.