To Next PageTo Next Page
Need help?Do you have a question about the Microsemi SyncServer S650 and is the answer not in the manual?
Lists key features such as accuracy, frequency accuracy, and modular architecture with FlexPort technology.
Discusses inherent security features, web interface hardening, NTP, and optional authentication services.
Explains the Phoenix connector for alarm relay output and its configuration.
Explains how to make AC and DC power connections and frame ground connections.
Covers configuration management via keypad, web interface, and CLI.
Explains using the Command Line Interface from a terminal connected to the serial port or Ethernet LAN1 port.
Reviews information before installation, including contact details and security considerations for the SyncServer S6x0.
Offers guidelines for installing the SyncServer S6x0 chassis into a standard 19-inch equipment rack.
Provides procedures for connecting the GNSS antenna, including proper cable routing and grounding.
Details the procedure for turning on power at the distribution panel after installation and connections.
Accesses windows for Ethernet, SNMP, SNMP Trap configuration, and Ping.
Window to configure NTP reflector and PTP services, allowing multiple configurations mapped to ports.
Window to map NTP reflector or PTP service to a LAN port, requiring licenses for most services.
Accesses windows to enable time/holdover sources, set time, time zone, and configure serial output.
Enables external time/frequency references, sets time, and configures IRIG year, UTC offset, and leap second notification.
Configures GNSS position and operating mode, including constellation selection and position modes.
Accesses configuration for security settings like Users, Access Control, HTTPS, SSH, NTPd, RADIUS, and LDAP.
Manages users, allowing adding or deleting users and password maintenance with specified character constraints.
Configures access control for LAN1-LAN6 (whitelist), accepting packets only from specified IP addresses.
Configures the web server and self-signed certificate information, detailing supported HTTPS protocols.
Enables and configures RADIUS authentication servers, with fail-over capabilities.
Enables and configures TACACS+ authentication servers, with iterative purpose for fail-over.
Accesses windows for general configuration, alarm relay, alarm configuration, email, banner, serial port, and software upgrades.
Provides the procedure to upgrade system software, noting that the system will reboot afterward.
Describes how to add, edit, or delete user names in the access list for Web GUI login.
Explains using external references like GNSS for frequency and TOD alignment, based on priority.
Explains how to add and modify NTP associations with different roles and IP addresses.
Covers NTP security features like symmetric keys and autokey server/client configurations.
Explains associating network timing services with physical network ports for operation.
Describes controls for provisioning and managing system alarms, including severity levels and notification methods.
Details how to provision SNMP functionality for network management and trap generation.
Provides guidelines for safety when working on or around live equipment.
Explains how LEDs and System Messages help in troubleshooting the SyncServer S6x0.
Explains how to upgrade firmware using the web interface and software from Microsemi.
Provides information and procedures for planning and installing a GNSS antenna.
General
