098-00720-000 Revision D1 – February, 2018 SyncServer 600 Series User’s Guide 165
Chapter 5
SyncServer S6x0 CLI Command Set
show image
Use this command to display current version in active and backup locations, as well
as which image will be used on boot.
Command Syntax:
show image
Example
SyncServer> show image
Response
SYSTEM IMAGE DETAILS
Active Image : 1
Backup Image : 2
Active Image Ver : 1.0.4
Backup Image Ver : 1.0.3.7
Next Boot Image : 1
This example tells us that:
The active image (what is currently running in SyncServer S6x0) is 1.0.4. Note
that this version is also displayed with the
show system command.
There is a backup image (2) and it contains software version 1.0.3.7.
Next Boot Image identifies that if a reboot occurs it will load image 1, which we
can deduce is the image we are currently running.
set image
This command provides the ability to control which software version will be loaded
on next power-up (or reboot).
Command Syntax:
set image (1 | 2}
Example
To set the next reboot to use the image 2:
SyncServer> set image 2
To Next Page
Loading...
