Microsemi SyncServer S650 - Network > SNMP Traps Parameters

098-00720-000 Revision D1 – February, 2018 SyncServer 600 Series User’s Guide 291
Appendix B Specifications and Factory Defaults
Factory Defaults
Priv Phrase (v3 User) Blank (no val [ <printable ASCII> ], 1 - 49 chars
Auth Phrase (v3 User) Blank (no val [ <printable ASCII> ], 1 - 49 chars
Min Priv (v3 User) Authentication Authentication |
Authentication & Privacy
Auth Crypt (v3 User) Blank (no value) MD5 | SHA
Table B-32. Network > SNMP Traps Parameters
Description Default Value Value Range
IP Address Blank (no value) <IPv4_address> |
<IPv6_address>
v2c and v3 No Select No Select | v2c | v3
User / Community Blank (no value) [ <printable ASCII> ], 1 - 32 chars
Send as Inform uncheck uncheck | check
Auth Phrase (v3) Blank (no value) [ <printable ASCII> ], 1 - 99 chars
MD5 / SHA (v3) No check If v3 check then [ <MD5 check> |
<SHA check> ]
Priv Phrase (v3) Blank (no value) [ <printable ASCII> ], 1 - 99 chars
Table B-31. Network > SNMP Parameters (Continued)
Description Default Value Value Range