Microsemi SyncServer S650 - Provisioning IRIG Inputs on Timing I;O Module

098-00720-000 Revision D1 – February, 2018 SyncServer 600 Series User’s Guide 187
Chapter 6 Provisioning
Provisioning Input References
Provisioning IRIG Inputs on Timing I/O Module
IRIG inputs are supported on Port J1 of the Timing I/O module with the SyncServer
S650.
Note: A Flex Port Option license is required for full configurability of
all BNC connectors on the Timing I/O module.
Note: The system will automatically detect and decode the
modulation frequency of AM-modulated IRIG inputs, regardless of the
configured AM modulation frequency. The clockAccuracy value will
be based on the configured AM modulation frequency and not the
actual input signal modulation frequency.