Microsemi SyncServer S650 - Timing Relationship between 1 PPS and TOD for 1 PPS+TOD Outputs; Syncserver S6 X0 10 Mhz Output Signal Specifications; Syncserver S6 X0 1 PPS Output Signal Specifications

098-00720-000 Revision D1 – February, 2018 SyncServer 600 Series User’s Guide 279
Appendix B Specifications and Factory Defaults
Specifications
Figure B-1. Timing Relationship Between 1PPS and TOD for 1 PPS+TOD Outputs
10 / 5 / 1 MHz Output
The 10/5/1 MHz outputs are available with the Optional Timing I/O Module.
1PPS x N Output Signal Specifications
The 1PPS x N outputs are available with the Optional Timing I/O Module.
Table B-18. SyncServer S6x0 10 MHz Output Signal Specifications
Parameter Specification
Signal type Sine wave
Connector type BNC male
Connector Label J3 - J8
Impedance 50 
Signal Level 2 - 3 Vpp
Table B-19. SyncServer S6x0 1PPS Output Signal Specifications
Parameter Specification
Signal type Rising edge on-time
TTL
Settings - Fixed Rate
 10/5/1MPPS
 100/10/1/kPPS
 100/10/1/0.5PPS
 1PPM
Settings - Programmable Period 100 ns to 2 sec, step size of 10 ns